Here at Absolute Training we give each and every candidate our Absolute Attention, if you want to succeed, call Absolute Training.
Points Operator (PO)
Venues for the Points Operator (PO) Course:
Abercynon or Customer's Own Site
Who Should Attend the Points Operator (PO) Course
For those who are required to manually operate power operated points which have failed or have been disconnected. A Points Operator works to the instructions of a Signaller or Route Setting Agent, according to the complexity of the failure.
Objectives for the Points Operator (PO) Course
On successful completion of the course delegates will be able to:
- Demonstrate their ability to interpret relevant sections of the Rule Book/Handbook
- Demonstrate their understanding and ability to manually operate failed power points motors in line with relevant rules and regulations
Content of the Points Operator (PO) Course
- Introduction
- Motors and points
- Normal operation
- Point operation terms
- Duties
- Procedure review
- Practical exercise
- Theory and practical assessments
Learning Approach for the Points Operator (PO) Course
Classroom based theory and practical exercises with some on-site practical exercises. Theory and practical assessments are included.
Features of the Points Operator (PO) Course
On successful completion of this event a certificate will be issued, which will be valid for 2 years. Delegates must attend re-certification training every 2 years to maintain their competence certification.
Special Requirements for the Points Operator (PO) Course
- A valid Track Safety certificate endorsed with either IWA or COSS Competence must be presented to the trainer at the start of each event
- A Rule Book must be brought to the event by each delegate
- A high visibility vest, outdoor clothing and safety footwear is required on this event
For further information on the Points Operator (PO) Course or any other courses please contact us
Please see below for further information about the Accredited Rail Safety Courses we offer:
- Personal Track Safety (PTS)
- Track Induction (TIC)
- Lookout/Site Warden (LKT)
- Controller of Site Safety (COSS)
- Controller of Site Safety Recertification (COSSR)
- Hand Trolley Controller
- Protection Controller (PC)
- Engineering Supervisor (ES)
Please see below for further information about the Auxillary Operating Duties Courses we offer: